A8 Overview 40
Status
Condition
Link indicator is amber and activity indicator
is off
The NIC is connected to a valid network at less than its
maximum port speed and data is not being sent or
received.
Link indicator is blinking green and activity is
off
NIC identity is enabled through the NIC configuration utility.
PSU Indicator Codes
AC power supply units (PSUs) have an illuminated translucent handle that serves as an
indicator. The DC PSUs have an LED that serves as an indicator.
The indicator shows whether power is present or if a power fault has occurred
Figure 36. PSU Indicator Diagram
1. AC PSU status indicator/handle
Table 28. PSU Indicator Diagram
Power indicator codes
Condition
Green
A valid power source is connected to the PSU and the PSU is operational
Blinking amber
Indicates a problem with the PSU
Not illuminated
Power is not connected to the PSU.
Blinking green
When the firmware of the PSU is being updated, the PSU handle blinks
green
CAUTION:
Do not disconnect the power cord or unplug the PSU when
updating firmware. If firmware update is interrupted, the PSUs do not
function.
Blinking green and turns off
When hot-plugging a PSU, the PSU handle blinks green five times at a rate
of 4 Hz and turns off. This indicates a PSU mismatch with respect to
efficiency, feature set, health status, or supported voltage
CAUTION:
If two PSUs are installed, both the PSUs must have the same type
of label; for example, Extended Power Performance (EPP) label. Mixing
PSUs from previous generations of PowerEdge servers is not supported,
even if the PSUs have the same power rating. This results in a PSU
mismatch condition or failure to turn the system on.
CAUTION:
When correcting a PSU mismatch, replace only the PSU with the
blinking indicator. Swapping the PSU to make a matched pair can result in
an error condition and unexpected system shutdown. To change from a
Summary of Contents for A8
