Razor 13111261, Owner'S Manual

B

B

A

A

8-2

8-4

8-4 8-2

8-1

8-1

8-3

8-3

8-5

7

Need Help?

 Visit our website for replacement parts, product support, a list of authorized service centers in the US and customer service contact information 

at 

www.razor.com

. Please have the product I.D. code (located on the white label of your product) available for better assistance. Additional Customer 

Service contact information is listed at the back of this manual.

REPAIR AND MAINTENANCE

1

 To adjust brake cable play, thread 

the brake lever adjuster in or out 1/4 

to 1/2 turn until the desired brake 

adjustment is attained. Most adjust-

ments are complete at this step. If 

brake still needs further adjustment, 

proceed to step 2.

2

If brake is too tight or has too 

much slack, use a 10 mm wrench 

to loosen the brake cable and 

adjust accordingly. 

3

Inspect the brake pads (A) for 

proper alignment against the wheel 

or excess wear. To realign brake 

pads, loosen the fixing nut (B) and 

adjust the pad to contact the rim. 

Re-tighten and readjust as needed. 

Verify proper brake function prior to 

riding the scooter.

 Adjusting the Brake

Required Tool:

 10 mm Wrench (not included)

Turn power “OFF” before beginning repair or maintenance:

• Read the instructions
• Remove charger plug
• Turn the power off

• Secure the product under repair
• Exercise caution around  

exposed parts

• Contact Razor customer service 

if unsure about any repair or 

maintenance

Right Side (Throttle)

8-4  Spacer

8-3  Washer

8-2  Spring Washer

8-1  M10 locknut

Middle

8-5  Front axle bolt

Left Side (Brake)

8-4  Spacer

8-3  Washer

8-2  Spring Washer

8-1  M10 locknut

1 

Using two (2) 16 mm wrenches, loosen the axle bolt.

Remove wheel and install replacement wheel.  

(Note the sequence of the hardware) 

q 

Front Tire  Replacement 

Required Tools:

Two (2) 16 mm Wrenches (not included)

Note:

Front wheel  

hardware sequence