Razor 13111261, Owner'S Manual

8-1

8-2

E1XX US VERSION 

--- wheel hard

ware sequence

Front wheel h

ardware sequence

Rear wheel hardware sequence

8-1

8-2

8-5

8-6

8-3

8-7

8-7

B

A

6

REPAIR AND MAINTENANCE

 Replacing the Chain and Rear Wheel 

Required Tools: 

Phillips Screwdriver and Two (2) 13 mm Wrenches (not included)

2

Using two (2) 13 mm wrenches, 

loosen the locknuts by turning the 

wrenches counter clockwise. 

1

Using a Phillips screwdriver, 

loosen the two (2) screws on the 

chain guard and remove.

3

To loosen the chain, pushing 

the tensioner down to create some 

slack in the chain.

1 

Using a 10 mm wrench loosen 

the brake cable bolt. 

 Replacing the Front Wheel

Required Tool: 

10 mm Wrench and Two (2) 16 mm Wrenches (not included)

2

Using two (2) 16 mm wrenches, 

loosen the locknuts by turning 

the wrenches counter clockwise. 

Remove wheel and install 

replacement wheel. 

(Note sequence of hardware.)

Right Side (Throttle)

8-3 Spacer
8-2 Washer

Fork

8-7  Spring Washer
8-1  16 mm Locknut

Left Side (Brake)

8-5 Spacer
8-2 Washer

Fork

8-7  Spring Washer
8-1  16 mm Locknut

Middle

8-6 Front Axle Bolt

Note:

Front wheel hardware 

sequence

1

 To adjust brake cable play, thread 

the brake lever adjuster in or out 

1/4 to 1/2 turn until the desired 

brake adjustment is attained. Most 

adjustments are complete at this 

step. If brake still needs further 

adjustment, proceed to step 2.

2

If brake is too tight or has too 

much slack, use a 10 mm wrench 

to loosen the brake cable and 

adjust accordingly. 

3

Inspect the brake pads (A) for 

proper alignment against the wheel 

or excess wear. To realign brake 

pads, loosen the fixing nut (B) and 

adjust the pad to contact the rim. 

Re-tighten and readjust as needed. 

Verify proper brake function prior to 

riding the scooter.

 Adjusting the Brake

Required Tool:

 10 mm Wrench (not included)

3

Reassemble, adjust and tighten 

brake cable. Verify proper brake 

function prior to riding the scooter. 

Turn power switch “OFF” before beginning repair or maintenance:

• Read the instructions
• Remove charger plug
• Turn the power switch off

• Secure the unit under repair
• Exercise caution around  

exposed parts

• Contact Razor customer service 

if unsure about any repair or 

maintenance