WARNINg:
Failure to
properly engage the spring-loaded
buttons may cause the handlebars
to dislodge while riding and may
cause you to lose control and
fall. When correctly engaged the
handlebars will not rotate nor will
they move sideways. Note that
when properly engaged, the spring-
loaded buttons are clearly visible in
the holes on the T-tube.
2
Make certain the spring-loaded
button engages the hole in the
T-bar for each handlebar.
1
Insert and secure the left and
right handlebars by pressing the
spring-loaded buttons and
inserting them into the T-tube.
SET Up AND USAgE INSTRUCTIONS
3
To release the folding
mechanism, hold the T-tube with
one hand between the collar clamp
and the quick-release lever and
place your foot on the deck plate.
With the other hand, pull the
joint lever up to release the steer-
ing column from the locked position
and allow you to pivot it to the
upright position.
4
The Joint lever is spring-loaded
and will automatically lock in the
upright position when fully upright.
WARNINg:
Keep
your fingers clear of the pivoting
mechanism when folding or
unfolding the scooter. Make sure
others are standing clear.
5
To adjust the height of the
handlebars, unlock the extension
tube by pulling outward on the
quick-release lever and pushing the
button located on the extension
tube. Slide the T-tube to the desired
position and secure by pushing
inward on the quick release lever.
6
The tension of the quick-release
lever can be adjusted by tightening
or loosening the allen bolt. Be care-
ful not to over-tighten. You should
always be able to open and close
the quick-release lever by hand and
the T-tube should slide freely with
the quick-release open.
WARNINg:
Failure to
properly engage the quick-release
lever may cause the T-tube to side
up or down while riding which
may cause you to lose control
and fall. With the quick-release
properly adjusted and engaged,
the handlebars will not move up or
down.
Using the 5mm Allen wrench, check that the collar clamp bolt is tightened securely. This item is tightened and quality
inspected at the factory, but there is a slight chance that the effects of
shipping or handling may have caused this bolt to loosen.
CHECk BEFORE RIDINg
Unfolding the scooter for first time use.
Collar Clamp
