Need help? Call 1.800.694.0013
Do not return to place of purchase.
Replacement Parts
1.800.694.0013
11
Installing LP Gas Tank
To operate, you will need one precision-filled standard barbecue
grill LP gas tank with external valve threads .
W
CAUTION: LP gas tank must be properly
disconnected and removed prior to moving this
griddle.
Inserting and Securing LP Gas Tank
1 . Unfold the upper LP gas tank support .
2 . Unfold the lower LP Gas tank support .
3 . Place precision-filled LP gas tank upright onto the upper and lower LP gas tank support so
the tank valve is facing the gas line connection .
Connecting LP Gas Tank
1 . Make sure control knobs are in the “ OFF” position
(Figure 2) .
2 . Before connecting, be sure there is no debris caught
in the head of the LP gas tank, head of the regulator
valve or in the head of the burner or burner ports .
3 . Connect regulator/hose assembly to tank by turning
knob clockwise until it stops .
4 . Perform leak test per “Checking for Leaks” section .
Disconnecting LP Gas Tank
1 . Make sure control knobs are in the “ OFF” position
(Figure 2) .
2 . Before disconnecting, make sure the LP gas tank valve
is “CLOSED .”
3 . Disconnect regulator/hose assembly from LP gas tank
by turning knob counterclockwise until it is loose .
W
CAUTION: LP gas tank must be properly
disconnected and removed prior to
moving this griddle.
4 . Place the protective cap cover on the LP tank and
store the tank outdoors in a well ventilated area out of direct sunlight .
20 lb
9 Kg
17.9 in.
/ 45.5 cm
12.2 in. / 31 cm
Operating Instructions
Checking for Leaks
Burner Connections
1 . Make sure the regulator hose and valve
connections are securely fastened to the burner
and the tank .
2 . Visually check the connection between the burner/
venturi tube and orifice .
3 . Make sure the burner/venturi tube fits over the
orifice .
W
WARNING: Failure to inspect this
connection or follow these instructions
could cause a fire or an explosion
which can cause death, serious bodily
injury or damage to property.
4 . Please refer to diagram for proper installation
(Figure 1) .
5 . If the burner/venturi tube does not rest flush to the
orifice, as shown, please contact 1 .800 .694 .0013
for assistance .
Tank/Gas Line Connection
1 . Make 2-3 oz . of leak detection solution by mixing
one part liquid dish washing soap with three parts
water .
2 . Make sure control knobs are in the “ OFF”
position (Figure 2) .
3 . Connect LP gas tank per “Installing LP Gas Tank”
section .
4 . Turn LP gas tank valve to “OPEN .”
5 . Spoon several drops of solution, or use a squirt
bottle, at all “X” locations (Figures 1 and 3) .
a . If any bubbles appear, turn LP gas tank valve to
“CLOSED,” reconnect and re-test .
b . If you continue to see bubbles after several
attempts, turn LP gas tank valve to “CLOSED”
and disconnect LP gas tank, per “Disconnecting
LP Gas Tank” section . Contact 1 .800 .694 .0013
for assistance .
c . If no bubbles appear after one minute, turn LP
gas tank valve to “CLOSED,” wipe away solution
and proceed .
Operating Main Burners
First Use
1 . Make sure all labels, packaging and protective
films have been removed from the griddle .
2 . Light griddle per “Lighting” section .
3 . Remove manufacturing oils before cooking on this
griddle for the first time .
4. Season your griddle per “Seasoning Griddle”
section.
Lighting
W
CAUTION: Keep outdoor gas cooking
appliance area clear and free from
combustible materials, gasoline and
other flammable vapors and liquids.
W
CAUTION: Do NOT obstruct the flow of
combustion and ventilation air.
W
CAUTION: Check and clean burner/
venturi tubes for insects and insect
nests. A clogged tube can lead to a
fire.
W
CAUTION: Do NOT use non-stick
cooking sprays because they contain
a lot of water and can burn onto the
griddle, damaging the surface.
W
CAUTION: Do NOT use corn oil as it
contains a high level of sugar, which can carmelize and burn onto the
surface.
1 . Open side shelves .
2 . Check for obstructions of airflow to the burners . Spiders, insects and webs can clog the
burner/venturi tube . A clogged burner tube can lead to a fire .
3 . All control knobs must be in the “ OFF” position (Figure 2) .
4 . Connect LP gas tank per “Installing LP Gas Tank” section .
Figure 1
Burner/
Venturi Tube
LP Gas
Valve with
Orifice
LP Gas
Connection
Figure 2
OFF
APAGADO
Figure 3
X
X
X
X
X
Figure 4
Lighting
Hook
Match
Figure 5
Lighting
Hook
Match
