6
Need Help?
Visit our website for replacement parts and product support at
www.razor.com
or call toll-free at
866-467-2967 Monday - Friday 8:00 AM - 5:00 PM Pacific Time. Please have the product I.D. code (located on the
bottom of the frame) available for better assistance.
2
Using a Phillips screw driver,
remove the three (3) screws on the
chain guard and remove the chain
guard.
3
Using two (2) 16 mm wrenches,
remove the locknuts on the front
axle bolt and slide axle bolt out
from the front wheel. Carefully
remove the chain from around the
wheel sprocket and remove wheel
from the front fork. If replacing the
chain, also remove the chain from
around the motor shaft. Install
replacement wheel/chain.
1
Carefully flip unit upside down
and using a 24 mm wrench; loosen
nut on the caster and remove
caster.
2
Using two (2) 5 mm Allen
wrenches; loosen coupling bolt
and remove wheel. Install the
wheel into replacement caster.
Install replacement caster on the
Crazy Cart and tighten securely.
q
Rear Wheels/Rear Casters Replacement
WARNING:
Failure to
properly adjust and tighten the
screws, nuts and bolts that affix
the wheels can cause you to lose
control and crash.
Note:
Practice riding only in wide
open areas clear from curbs,
parking blocks and other obstacles.
Impacting the wheels against
any hard surface can damage the
wheels. Wheels are not covered
under your limited warranty.
WARNING:
Failure to
properly install and tighten the
screws, nuts and bolts that affix the
steering wheel and seat can cause
you to lose control and crash.
Note:
Front wheel hardware
sequence
q
front Wheel/Chain Replacement
Turn power switch off before conducting any maintenance procedures.
1
Using a Phillips screw driver,
remove the four (4) screws on the
right side of the motor cover (side
of the foot pedal throttle) and
remove cover.
Right Side (Throttle)
7-1 Locknut
7-2 Split Washer
7-3 Flat Washer
Fork
7-4 Spacer
Left Side (Brake)
7-1 Locknut
7-2 Split Washer
7-3 Flat Washer
Fork
7-4 Spacer
7-1
7-4
7-2
7-3
7-3
7-2
7-4
7-1
REPAIR AND mAINTENANCE
