3
Need Help?
Visit our website for replacement parts, product support, a list of authorized service centers in the US and customer service contact information
at
www.razor.com
. Please have the product I.D. code (located on the white label of your product) available for better assistance. Additional Customer Service
contact information is listed at the back of this manual.
BEFORE YOU BEGIN
Remove contents from box. Remove the separators that protect the components from damage during shipping. Inspect
the contents of the box for scratches in the paint or dents that may have occurred during shipping. Because your product
was partially assembled and packed at the factory there should not be any problems, even if the box has a few scars or
dents.
MAKE SURE POWER SWITCH IS TURNED “OFF” BEFORE CONDUCTING ANY ASSEMBLY OR
MAINTENANCE PROCEDURES.
Estimated Assembly and Set-Up Time
Allow up to 15-20 minutes for assembly, not including initial charge time.
Allow up to 5 hours for charge
(see page 8 for charging information).
2.
Charger
(Note: Charger design may
vary from one shown)
Throttle
Foot Pad
Hand Brake
1. Battery Cover
Rear Caster Wheel
Seat
3. Frame
Hub Motor
5 mm Allen Wrench
Phillips Screwdriver /
5 mm Allen Wrench
(Combination Tool)
10 mm / 13 mm Wrench
WARNING:
DO NOT USE
NON-RAZOR PRODUCTS WITH
YOUR Drift Rider.
The Drift Rider has been built to
certain Razor design specifications.
The original equipment supplied at
the time of sale was selected on
the basis of its compatibility with
the frame, fork and all other parts.
Certain aftermarket products may
not be compatible and will void
your warranty.
Product ID Locations:
(See locations to the left)
1. Behind Battery Cover
2. Charger
3. Underneath Frame
Plastic Bag Contents:
• Charger
• Tools
• Owner’s Manual
• Eight (8) Phillips Screws
Required Tools
Summary of Contents for DRIFT RIDER
Page 2: ......
