3
ASSEMBLY AND SET-UP
Assembling the Frame
Required Tools:
Two (2) 5 mm Allen Wrenches
1
Using a 5 mm Allen wrench
and a 13 mm wrench, remove
the steering bolt and locknut
from the downtube.
Note:
Place fi nger underneath
the downtube to prevent the
bottom bushing from falling
out and getting lost.
Attaching the Front Fork
Required Tools:
5 mm Allen Wrench and 13 mm Wrench
2
Using a 13 mm wrench,
loosen the two (2) bolts on
the upper crown.
3
Re-insert the bottom bushing
into the downtube then carefully
slide the downtube between the
upper and lower crowns.
4
Align the downtube with the hole in the upper and
lower crown and re-insert the steering bolt. Securely
tighten using a 5 mm Allen wrench and a 13 mm wrench.
5
Re-tighten the two (2) 13 mm bolts on the
upper crown.
WARNING:
Failing to
properly tighten the steering bolt that
attaches the front fork assembly to
the frame assembly can cause you to
lose control and fall.
1
Using two (2) 5 mm
Allen wrenches, remove the
two (2) coupling bolts from the
downtube. Remove and discard
the plastic insert.
4
Re-insert the
shorter
coupling
bolt (A) through the center
frame and downtube and tighten
securely in place.
3
Re-insert the
longer
coupling
bolt (B) through downtube and
rear frame and tighten securely
in place.
2
Connect the downtube to the
rear frame and align the holes on
the downtube with the holes on
the rear frame.
A
(Shorter)
B
(Longer)
Grip Side Up
