WARNING:
Do not use the DXT for the fi rst time
until you have infl ated the tire to
the correct PSI. Failure to do so may
damage your drift trike and will void
your warranty.
WARNING:
Do not over infl ate, as this could
damage the tire or wheel.
Note:
The pressurized air supplies
found at gasoline stations are
designed to infl ate high-volume
automobile tires. If you decide to
use such an air supply to infl ate
your tire, fi rst make sure the
pressure gauge is working, then
use very short bursts to infl ate to
the correct PSI. If you inadvertently
over-infl ate the tire, release the
excess pressure immediately.
Infl ating the Tire
The tire is infl ated when shipped, but will invariably lose some pressure between the point of manufacturing and your
purchase.
Infl ate the tire to the correct PSI before fi rst time use.
Periodically check the tire. Reinfl ate when needed.
1
Using a bicycle tire pump equipped for a Schrader valve, infl ate the
front tire to the PSI indicated on the sidewall of the tire.
5
ASSEMBLY AND SET-UP
Attaching Flag
1
Assemble fl ag as shown
2
Insert fl ag into fi xed hole located on seat.
