Razor ECOSMART CARGO, Owner'S Manual

HEADLINE

10

USAGE

10

 How to Stop

1.  To stop, release the throttle 

(B)

 and apply the brake, by squeezing the brake lever 

(D)

, until the product comes to a 

complete stop

. When coming to a complete stop, place both feet on the ground to balance the electric scooter.

2.  Make sure to turn the product 

OFF

 after your ride is complete. Pressing the power button 

(A)

 for two seconds 

will turn the product 

OFF

 completely.

Note:

 When the brake is applied the tail/brake light will flash. The brake light is always functional and independent 

of the other lights being activated.

WARNING: 

The brake is 

capable of skidding the rear tire 

and throwing an unsuspecting rider. 

Practice in an open area free from 

obstacles until you are familiar with 

the brake function. Avoid skidding to 

a stop as this can cause you to lose 

control and/or damage the rear tire.

Note:

 As an additional safety 

feature, the scooter is designed to 

cut power to the motor when the 

hand brake is applied.

Note: 

Practice riding only in wide 

open areas clear from curbs, 

parking blocks and other obstacles. 

Impacting the wheels against 

any hard surface can damage the 

wheels. Wheels are not covered 

under the limited warranty.

B

D

A

3

 Press the bottom area of the 

display (as shown) to decrease 

speed levels in increments of one 

(1). Each time you press the bottom 

area of the display you will move to 

the next lower speed level until you 

reach the lowest speed level (0).

 Changing the Speed Level

Speed levels are controlled on the display. The display is activated when the power on the EcoSmart Cargo is in the 

“ON” position. Practice in an open area free from obstacles until you are familiar with changing speed levels. Riders 

can toggle speed levels up or down while the EcoSmart Cargo is in motion. Higher speed levels will result in higher 

speeds and lower speed levels will result in lower speeds. There are five (5) speed levels. The EcoSmart Cargo is set 

on speed level 0 (no speed) setting at the factory. 

1

 Each bar at the top of the display 

represents a speed level. When all 

the bars are off, EcoSmart Cargo is 

at speed level 0.

2

 Press the top area of the display 

(as shown) to increase speed levels 

in increments of one (1). Each time 

you press the top area of the display 

you will move to the next higher 

speed level until you reach the 

maximum speed level (5).

Note: Once the electric scooter is powered OFF, speed levels are disabled. Speed level will reset to 

level 0 each time you power ON your electric scooter.