Razor Flash RideR, Owner'S Manual

4

q 

Attaching the Rear Caster Wheels 

Required Tools: 5mm Allen wrench

1

Remove the four coupling 

bolts from the frame using two 

5mm Allen wrenches; one on top 

and one on bottom.

2

Align the four holes in seat 

with the four holes in frame. Insert 

coupling bolts through the top and 

bottom of the frame.

q 

Attaching the Seat 

Required Tools: (2) 5mm Allen wrench

 ASSEMBLy AND SET-UP

3

Tighten bolts using two 5mm 

Allen wrenches; one on top and 

one on bottom.

2

Using a 5mm Allen wrench, 

tighten the hex bolt located on the 

underside of the wheel cover until 

the caster bolt is all the way inside 

the frame.  

Note:

 There should be no visible 

threading between the frame and 
the wheel cover (See Inset)     

3

If you’re having trouble thread-

ing the caster into frame, use a rag 

or small brush with a little WD-

40® to remove any excess particles 

that may be caught in or around the 

threading within the frame.          

Need Help?

 Visit our web site for replacement parts and product support at 

www.razor.com,

 or call toll-free 

at 866-467-2967 Monday - Friday 8:00 AM - 5:00 PM Pacific Time.

1

Insert the caster bolt into the 

frame.  If aligned correctly, the caster 

thread should go half way into the 

frame with no resistance.  

Note:

  Make sure the spring washer 

is on the caster bolt before inserting 

the caster. 

Meijer.com