background image

Outdoor Portable LP Gas Griddle

Model No. GGC2226M

12 

Troubleshooting

Problem

Possible Cause

Prevention/Cure

Burner will not light using igniter

LP gas tank valve is closed

Make sure regulator is securely attached to the LP gas tank per “Installing 
LP Gas Tank,” then turn LP gas tank valve to “OPEN”

LP gas tank is low or empty

Exchange, refill or replace LP gas tank

LP gas

1.  Turn LP gas tank valve to “CLOSED”
2.  Wait 5 minutes for gas to clear
3.  Follow “Checking for Leaks” section

Wires or electrode covered with cooking residue

Clean wire and/or electrode with rubbing alcohol

Electrode and burners are wet

Wipe dry with cloth

Electrode cracked/broken - sparks at crack

Replacement part(s) may be needed - contact Customer Care at 
1.800.694.0013

Wire loose or disconnected

Reconnect wire or replacement part(s) may be needed - contact Customer 
Care at 1.800.694.0013

Wire is shorting (sparking) between igniter and 
electrode

Replacement part(s) may be needed - contact Customer Care at 
1.800.694.0013

Bad igniter

Replacement part(s) may be needed - contact Customer Care at 
1.800.694.0013

Burner will not light with match

No gas flow

Check if LP gas tank is empty

A. If empty, exchange, refill or replace LP gas tank
B.  If LP gas tank is not empty, refer to “Sudden drop in gas flow or 

reduced flame height” (see below)

LP gas tank is low or empty

Exchange, refill or replace LP gas tank

LP gas

1.  Turn LP gas tank valve to “CLOSED”
2.  Wait 5 minutes for gas to clear
3.  Follow “Checking for Leaks” section

Coupling nut and regulator not fully connected

Turn the coupling nut about one-half to three-quarters additional turn until 
solid stop. Tighten by hand only - do NOT use tools

Obstruction of gas flow

1.  Clear burner/venturi tube
2.  Check for bent or kinked hose

Disengagement of burner to valve

Re-engage burner and valve

Spider webs or insect nest in venturi

Clean burner/venturi tube

Burner ports clogged or blocked

Clean burner ports

Sudden drop in gas flow or reduced flame height

Out of gas

Exchange, refill or replace LP gas tank

Overfilling prevention device may have been 
activated

1.  Turn control knobs to “  OFF”
2.  Wait 30 seconds and light griddle
3.   If flames are still too low, reset the overfilling prevention device:

a.  Turn control knob(s) “  OFF”
b.  Turn LP gas tank valve to “CLOSED”
c.  Disconnect regulator
d.  Turn control knobs to   (HIGH)
e.  Wait 1 minute
f.  Turn control knobs to “  OFF”
g.  Reconnect regulator and leak check connections, being careful 

not to fully open valve

h.  Light griddle per “Lighting” section

Irregular flame pattern, flame does not run the 
full length of burner

Burner ports are clogged or blocked

Clean burner ports

Flame is yellow or orange

New burner may have residual manufacturing oils

Burn griddle for 15 minutes on    (HIGH) 

Spider webs or insect nest in venturi

Clean venturi

Food residue, grease, etc. on burners

Clean burner

Poor alignment of valve to burner/venturi tube

Ensure burner/venturi tube is properly engaged with valve

Flame goes out

High or gusting winds

Do not use griddle in high winds

Low on LP Gas

Exchange, refill or replace LP gas tank

Overfilling prevention device may have been 
activated

Refer to “Sudden drop in gas flow or reduced flame height” (see above)

Flare-up

Grease buildup

Remove and clean all griddle parts per “Cleaning and Care” section

Excess fat in meat

Trim fat from meat before cooking

Excessive cooking temperature

Adjust to lower cooking temperature

Persistent grease fire

Grease trapped by food buildup around burner 
system

1.  Turn control knobs to “  OFF”
2.  Turn LP gas tank valve to “CLOSED”
3.  After griddle cools, remove and clean all parts per “Cleaning and 

Care” section

Flashback (fire in burner tube(s))

Burner and/or burner/venturi tube are blocked

Clean burners and/or burner/venturi tube

Griddle Surface

Griddle has started to rust

With use the griddle surface will rust, this is normal. Follow the “Refurbish 
the Griddle Surface” instructions in the “Seasoning Griddle” section to 
season your griddle surface.

Griddle surface looks dull

The cooking surface has gotten too hot, and is no longer seasoned. Season 
grill per “Seasoning Griddle” section.

For more assistance, please call 1.800.694.0013.

Summary of Contents for GGC2226M













Reviews: