Razor Ground force Drifter 25143400, Owner'S Manual

Turn power switch off before conducting any maintenance procedures.

1

 To remove a wheel, remove the 

self-locking nut (13mm socket or 

wrench required for front wheels, 

17mm for the rear wheels). Tap the 

wheel to remove.

1

 Remove the rear wheel.

4

 Remove c-clips on the axle 

between the two bearings.

5

 Lightly tap the end of the axle 

with a rubber mallet. DO NOT USE 

A HAMMER as this will damage the 

thread. The brake drum and pulley 

must be slid along the axle as your 

tapping progresses.

2

 To replace a front wheel, make 

sure the bearings are seated and 

the center spacer is installed. Posi-

tion the wheel with the Razor logo 

facing outward. Install the washer 

and tighten the self-locking nut 

securely.

2

 Use a 3mm wrench to loosen 

the brake.

6

 When the axle end is clear of 

the bearing hanger, remove and 

replace the chain. Reverse this 

procedure to reassemble.

2

 To replace a rear wheel, make 

sure the key is properly seated in 

the rear axle and aligned with the 

key in the wheel. Position the wheel 

with the Razor logo facing outward. 

Install the washer and tighten the 

self-locking nut securely.

3

 Use a 3mm wrench to loosen the 

sprocket.

5

 ASSEMBLy AND SET-UP

q 

Replacing the Wheels

q 

Replacing the Chain

       WARNING:

Failure 

to properly adust and tighten the 

screws, nuts and bolts that affix 

the wheels can cause you to lose 

control and crash.

Note:

 The Ground Force Drifter 

wheels must be replaced when worn 

down to the wear indicator line.

Note:

 Practice drift driving only in 

wide open areas clear from curbs, 

parking blocks and other obstacles. 

Impacting the wheels against 

any hard surface can damage the 

wheels. Wheels are not covered 

under your limited warranty.

Need Help?

 Visit our web site for replacement parts, product support and a list of authorized service centers 

at 

www.razor.com

 or call toll-free at 866-467-2967 Monday - Friday 8:00 AM - 5:00 PM Pacific Time.

Loosen

Tighten

Front and rear wheel installation and removal are the same.