Step 4: Install the new controller
Install the new replacement controller and tighten
the mounting screws (see Figure 4).
2
Figure 4
Step 5: Reconnect the wires
Need Help?
Visit our website for additional video instructions at
www.razor.com
or call toll-free at
866-467-2967
Monday - Friday
8:00am - 5:00pm Pacific Time.
Figure 5a
Reconnect all plug-in connectors (see Figure 5a).
Each connection point is unique, so the system can
only be connected in one way: the right way.
Note: If your existing controller has a 6-pin connector (see
Figure 5b), the replacement controller will require use of the
supplied adapter.
Figure 5b
Figure 2b
Each connector is a snap lock type connection
that requires depressing a small tab to allow the
connector to release (see Figure 2b). Do not
attempt to disconnect by pulling on the wires!
Step 2b:
Figure 3
Remove and save the two mounting screws that
secure the old controller. You should now be able to
remove and discard the old controller (see Figure 3).
Step 3: Remove the old controller
