5
Need Help?
Visit our web site for replacement parts, product support, a list of authorized service centers in the US and customer service contact information
at
www.razor.com
. Please have the product I.D. code (located on the white label of your product) available for better assistance. Additional Customer Service
contact information is listed at the back of this manual.
CHARGING THE BATTERY
Your Hovertrax comes with a built-in LiFeP04 (lithium ion phosphate) battery pack. Your Hovertrax may not have a fully
charged battery; therefore you must charge the battery prior to use. Be sure to charge the battery in a clean, dry location
away from direct sunlight, flames or sparks.
2
Plug the charger into the charger
port on the Hovertrax. The light on
the charger should turn red during
charging. The light will turn green
again when charging is complete.
1
Plug the charger plug into wall
outlet. The light on the charger
should be green.
Note:
If green light (LED) does not
turn on, try a different outlet.
WARNING:
Use ONLY with the recommended
charger. Batteries are only to be
charged under adult supervision.
The charger is not a toy. Always
disconnect the charger before wiping
down and/or cleaning the Hovertrax
with a damp cloth.
The charger supplied with the
Hovertrax should be regularly
examined for damage to the cord,
plug, enclosure and other parts.
In the event of such damage, the
Hovertrax must not be charged until
it has been repaired or replaced.
Chargers have built-in overcharge
protection to prevent battery from
being overcharged.
Note:
If the charger gets warm
during regular use, this is a normal
response and is no cause for
concern. If your charger does not get
warm during use, it does not mean
that it is not working properly.
Wall outlet - Green (stand by)
Wall outlet and unit - Red (charging)
Wall outlet and unit - Green (charged)
Note:
Continue charging unit even if
light turns green prior to 3 hours.
WARNING:
Failure to
recharge the battery at least once a
month may result in a battery that
will no longer accept a charge.
Charger
Note:
Make sure the power switch
is in the
OFF
position.
LED
• Initial charge time: 6 hours.
• Recharge time: up to 4 hours, even if the light turns green.
Recommended maximum charging time is 24 hours.
• Always charge the battery immediately after riding.
• Fully charge battery before storing for extended periods
of time.
• Unplug charger from the wall outlet when not in use.
• Failure to recharge battery periodically may result in a
battery that will not accept a charge.
• Make sure the Hovertrax power switch is turned
OFF
when unit is not in use. If the power switch is left on
for an extended period of time, the battery may reach a
stage at which it will no longer hold a charge.
• Run time: Up to 115 minutes of continuous ride time.
Run time may vary depending on riding conditions, rider
weight, climate, and/or proper maintenance.
• Constant stopping and starting may shorten ride time.
Battery Power Level Indicators
• Solid Green: Battery power level is 15 to 100 percent.
• Flashing Green: Battery power level is 5 to 15 percent, recommend charging.
• Solid Red: Battery power level is below 5 percent. Do not ride and charge immediately.
WARNING:
The
Hovertrax will notify you when the
battery charge is dangerously low
by slowing down and shaking the
wheels when you are riding it. If
these warnings occur, immediately
slow down and safely step off.
Turn the product off. Do not
attempt to ride again until the
battery is recharged.
Summary of Contents for HOVERTRAX
Page 2: ......
