10
Need Help?
Visit our web site for replacement parts, product support, a list of authorized service centers in the US and customer service contact information
at
www.razor.com
. Please have the product I.D. code (located on the white label of your product) available for better assistance. Additional Customer Service
contact information is listed at the back of this manual.
REPAIR AND MAINTENANCE
Adjusting the Brake
Required Tools:
Phillips screwdriver, 10 mm wrench
1
To adjust the brake cable
tension, thread the brake lever
adjuster in or out 1/4 to 1/2 turn
until the desired brake adjustment
is attained. Most adjustments are
complete at this step. If the brake
still needs further adjustment,
proceed to the following steps.
4
If the brake is too tight or too
loose, use a 10 mm wrench to
loosen the nut on the brake cable
for additional adjustment. Securely
tighten the nut when finished.
2
Using a Phillips screwdriver,
loosen the two (2) screws on the
foot pegs. Use an 8 mm wrench
to hold the lock nuts that keep the
screws in place.
5
Replace the motor cover/
chain guard. Refer to steps 2
and 3 above.
3
Using a Phillips screwdriver,
loosen the six (6) screws to remove
the motor cover/chain guard.
