HEADLINE
77
PRE-RIDE CHECKLIST
HEADLINE
ASSEMBLY AND SET-UP
Deck and Handlebars
Check for cracks or broken connections. Although broken
decks are rare, it is possible for an aggressive rider to run
into a curb or object and wreck and bend or break the deck.
Get in the habit of inspecting your scooter on a regular basis.
Hardware/Loose Parts
Check and secure all fasteners before every ride. Make sure
the handlebars and seat (if installed) are locked properly in
place before riding. There should not be any unusual rattles
or sounds from loose parts or broken components. If the unit
is damaged, do not ride.
Reference “Safety Warnings”
on pages 1 and 2 of this manual.
Safety Gear
Always wear proper protective gear, such as an approved
safety helmet. Elbow pads and kneepads are recommended.
Always wear closed toe shoes (lace-up with rubber soles) and
keep shoelaces tied and out of the way of the wheels. NEVER
RIDE BAREFOOTED OR IN SANDALS..
Laws and Regulations
Always check and obey any local laws or regulations.
Be Careful!
This product is not for aggressive or trick riding. Avoid steep
inclines and don’t ride too fast — you can lose control and
fall. Skateboard parks are not designed for young riders. Never
ride in traffic or on the street and watch your surroundings for
pedestrians, bikers, boarders and skaters.
Maintain a hold on the handlebars at all times.
WARNING:
Failure to
properly install and tighten the seat
may cause the rider to lose control
and fall. If you do not understand
these instructions, contact Razor
customer care for assistance.
Attaching the Seat (Continued)
Removing the Seat
Reverse steps 1-4 to remove the seat for stand up riding.
4
Insert the seat lock knob through the seat clamp and
steer tube threading it into the seat turning clockwise
to tighten.
