RAZORBACK OFFROAD
™
4
The following are general instructions for assembling the RBO1018 – “IT FITS™” Adjustable Spare Tire
Mount. Due to constant improvements in the design and quality of production components, some
minor discrepancies may result between the actual parts and the information presented.
ASSEMBLY INSTRUCTIONS:
Determining the Length of the “IT FITS™” Adjustable Spare Tire Mount to the Spare Tire
:
It is up to the installer to see that any accessory is securely mounted, and any tools used by the installer are used
and/or operated using common sense and that the installer follows the tools manufacturer’s
descriptions for intended use and recommendations.
RBO, its employees, and affiliates can assume no responsibility or liability for misuse of tools and/or improper
installations that may result in breakage, damage, injury, and/or death.
!
!
ATTENTION
STEP 1
(STEP 1.1)
Set the tire you wish to
mount on a flat surface
with the inner side facing down.
(STEP 1.2)
Measure from the flat surface to the bottom edge
of the wheel’s central bore. This is the minimum
length you will need to have in order to mount
your tire to your “IT FITS™” Adjustable Spare Tire
Mount. See Figure 1.
Record this measurement
in the box on page 7 for use in Step 3.3.
FLAT
SURFACE
BASE OF
CENTRAL
BORE
BORE TO
SURFACE
MEASUREMENT
(FIG. 1)
