5. Place the kettle back onto the base.
6. Plug the kettle into the mains electrical outlet and it enters standby mode. The
temperature display will light up and show the real-time temperature. Boil (212°F)
setting light flashes to indicate the default mode, then kettle is ready for
temperature selection.
7.
Press the
"+"
and
"-"
buttons to select the wanted temperature for the type of
tea you are brewing. During the temperature selection process, the selected
temperature light flashes and the other lights stay on.
8. Choose the mode of boiling. If you want to keep the water warm at the selected
temperature, press
“KEEP WARM”
button. If not, simply press
“START/CANCEL”
button
to begin.
NOTE:
If there is no operation within 3 minute after the kettle comes into temperature
selection state, the buzzer will sound 3 times. Then all lights are off, and the kettle
enters the standby mode.Press any button to wake the appliance.
06
Press
“KEEP WARM”
button after temperature selecting. The kettle immediately
starts working. The display will only show the selected temperature and the selected
temperature light is on.
KEEP WARM
Press
“START”
button after temperature selecting. The kettle starts working. The
display will only show the selected temperature and the selected temperature
light is on.
START
After the water boiled to the selected temperature, the buzzer will beep 3 times
and the screen will show the temperature which you selected. After 3 minutes all
the lights will off, and the kettle goes into standby mode. It will not re-boil until
the
“START”
button is pressed again.
After the water boiled to the selected temperature, it will beep 3 times and
automatically begin to keep warm. The display shows real-time temperature and
the selected temperature light keep flashing.
After 2-hours keep warm, the buzzer will beep 3 times and all the lights will off to
end the keep warm stage, the kettle goes into standby mode.
Summary of Contents for PDK17A
Page 1: ...材质 128g双铜 尺寸 145 210mm ...
Page 11: ......
