2
ASSEMBLY
Screw on the pump handle as shown to the left
or right hand side to suit the operator.
Fit the bottom end of the spray lance to the CF
valve and Female thread of the CF valve to the
trigger valve, ensuring that the 100 mesh filter
is fitted in the trigger valve and the connections
are all secure.
Make sure that the hose connections at the top
of the piston and trigger valve are tight.
Remove the bag containing the additional
nozzles and spare seals and o-rings from the
tank filter and keep in a safe place. Unscrew
the cylinder cap (part no 8376R) and put some
lubricant (vegetable oil) on the felt washer.
NOZZLE SELECTION
It is important for any spraying operation that the correct nozzle is used to ensure that
good coverage is obtained with the minimum amount of uncontrolled spray drift.
Different nozzles will give different spray patterns and droplet sizes. Before using the
sprayer for the first time it is advisable to fill the tank half full with water and pump
the system through with no nozzle fitted to remove any debris which could cause
nozzle blockage.
The
SA15
is supplied with a range of different nozzles. Using the table below as a
guide select and fit the nozzle most appropriate to the spray application from those
supplied. (Note that not all those listed are supplied with every sprayer).
Nozzle Type
Fungicides
Insecticides
Herbicides
Yellow deflector
X
X
√
Red Deflector
X
X
√
Yellow hollow cone
√
√
X
To ensure optimum benefits, check the nozzle for wear. Replace the nozzle if flow exceeds 10% of the Set
nozzle flow rate or replace nozzle after every 3 months of usage.