inside the engine after each day of use. To be sure, we
suggest you start the engine, let the engine run, and then
pinch the fuel line until the engine stops.
We suggest that you check the internal condition of your engine on regular
basis, and if you are not familiar with this then we recommend that you
ask your LHS or Dealer where you have purchased the engine to help you
to check the overall condition of your engine.
If you run your engine very hard it is also advised that you replace the
conrod after each 5 liters (1-1/2 gallons) of fuel run through the engine,
because the conrod is the most stressed part inside the engine. Failure to
do so may cause severe and irreversible damage to your engine. The
changing of the conrod is best done by an expert or with expert guidance.
Special attention should also be paid to the air filter. Make sure that it is
always in place, well secured, in good condition, and thoroughly oiled.
Please note that it is very important that if you want to maintain or repair
an engine yourself that you take care of the following;
·
Always clean the outside of the engine thoroughly before you
open it, work on a clean spot using appropriate tools, since any
dust or dirt which comes into the engine will cause irreversible
damage.
·
All moving parts inside the engine are subject to wear, so you
must know that if a piston and sleeve has worn, it is also probable
the crankshaft pin and conrod are worn, so you must inspect
and possibly replace these parts. If an engine has failed, you
must check if all other moving parts are still in good shape, since
if you only change the damaged part and other parts are not in
good shape, it is highly likely there will be a new failure soon.
www.rbproducts.com
Page 16
instruction manual
Summary of Contents for Concept engines
Page 19: ...10 Notes 10 Notes ...
