INSTALLATION, OPERATION AND MAINTENANCE INSTRUCTIONS
SYDNEY
|
MELBOURNE
|
BRISBANE
|
PERTH
|
AUCKLAND
Australia
1300 788 778 | www.rba.com.au
New Zealand
0800 722 111 | www.rbagroup.co.nz
SYDNEY
|
MELBOURNE
|
BRISBANE
|
PERTH
|
AUCKLAND
Australia
1300 788 778 www.rba.com.au
|
New Zealand
0800 722 111 www.rbagroup.co.nz
4
Installation Instructions
Installation must be carried out in accordance with local authority
requirements.
1.
Installation to be in accordance with the AS/NZ3500 series of
Standards plus all local and statutory requirements. For Australia,
Installation shall be in accordance with the PCA [Plumbing Code of
Australia] and any relevant local authority requirements.
2.
Flush the line thoroughly and remove all dirt and grit from the line
before connecting the tap
3.
Install the taps as shown in diagrams A-H (on page 5)
4.
Before turning on the water, remove aerator and flush the tap
5.
Replace aerator and check for leaks
6.
Insert the appropriate coloured indicator into the hole at the tap base
(typically blue for cold and yellow for warm water)
RBA1074-999-001 Details
The RBA1074-999-001 Angle Valve is a stop strainer that is supplied with the
Formatta Sensor Tap. This must be installed as part of the sensor tap
installation as it prevents debris from entering the sensor and causing issues
with diaphragm and flow control. Failure to install will void warranty.
To clean the strainer or isolate the sensor tap, simply use the special key
provided and turn the strainer counter clock wise and remove. The angle valve
contains a spring loaded stop that will automatically turn the water supply off
on removal. Clean strainer or isolate tap where required. Replace strainer to
turn the water supply back on.
+-
