INSTALLATION, OPERATION AND MAINTENANCE INSTRUCTIONS
SYDNEY
|
MELBOURNE
|
BRISBANE
|
PERTH
|
AUCKLAND
Australia
1300 788 778 www.rba.com.au
|
New Zealand
0800 722 111 www.rbagroup.co.nz
2
PRIOR TO INSTALLATION
All folding shower seat installations, where support legs go to the Finished
Floor Level [FFL], are unique due to the ‘fall’ of each individual fl oor. To ensure
accurate installation, ensure the seat is level and the legs fully extended to meet the
FFL before securing unit to the wall.
Warning:
Folding Shower Seats are no stronger than the anchors or walls to
which they are attached and, therefore, must be fi rmly secured in order to
support the loads for which they are intended.
INSTALLATION
RBA4157-777-005 Folding Shower Seat meets the requirements of Changing
Places Design Specifi cations 2020 when installed correctly.
1. Locate seat horizontally on wall to comply with Changing Places Design
Specifi cations 2020. Secure unit to wall at mounting points shown on dimensional
drawing.
2. Check to make sure seat surface is horizontal and frame is fl at against wall.
3. Check to see if seat moves freely from horizontal to vertical position.
4. Shower seat can be folded up when not in use.
OPERATION
Legs lock into place to by pushing the legs into the wall to prevent seat from
falling down when not in use.
To place seat back down from upright position pull both legs out and slowly lower
seat to horizontal position
INSTALLATION, OPERATION AND MAINTENANCE INSTRUCTIONS
SYDNEY
|
MELBOURNE
|
BRISBANE
|
PERTH
|
AUCKLAND
Australia
1300 788 778 www.rba.com.au
|
New Zealand
0800 722 111 www.rbagroup.co.nz
3
233
494
233
960±2
40±
1.
5
39
5
R 3
98
6
98
6
98
6
98
41
0
R15
R15
16
0
13
0.
5
450
55
75.0
25x25x1.2
92
47
9
276
25x5
10
0
10
0
42.
8
29
4
31
8
410
40
R2.5
694
12
25
ø7
m
m
