8
WWW.ROLLINGBIGPOWER.COM
Step 5:
Install the front Driver side motor using two M6 flange bolts to fasten the motor to the pinch seam and two M8
flange bolts to fasten the motor to the threaded nut bracket. Hold the bracket by the hang tab to avoid it falling into the
rocker panel. The hardware should be hand tightened only until snug. This will allow the motor assembly to move and
align easier when installing the running board.
Step 6:
Install the Driver Side running board.
6a. Begin by propping up the running board on the front and rear motor assembly bases.
6b. Next align the sliding T-Nut assemblies on the running board with the slots on the front and rear motor bases.
6c. Once the T-nuts are aligned, rotate the running board so that the T-nuts drop into the slots on the base of the arms.
6d. Secure the running board to the arms using the M6 x 25 socket head cap screws. Using a torque wrench, tighten to 9 ft-lbs.
INSTALLATION INSTRUCTIONS
Step 5A
Step 5B
Step 6A
Step 6C
Step 6B
Step 6D
