●
Model name: Self-explanatory... Change letter with +/- keys, go to the next with ENTER SHORT, or press
ENTER LONG to capitalize the current letter before switching to the next.
●
Model image: There you can select a 64x32px, 16-grayscale .bmp file located in the BMP folder of the SD
card as your model logo. To be able to preview the images in the folder, use the
SD Browser
.
●
Timers: There are 2 fully programmable timers, that can count either up or down. If the value is set to
00:00 they will count up from 0, if not they will count down from the preset value. The trigger is set using
the field next to the timer value, ABS counts up all the time, THs runs whenever the throttle stick isn't at
idle, THt starts the timer the first time throttle is advanced, TH% counts up as a percentage of the full stick
range. Persistent, if ticked, means the value is stored in memory when the radio is powered off or model is
changed, and will be reloaded next time the model is used. Minute call will beep / say the time every full
minute. Countdown can be set to Silent, Beeps or Voice. With Silent selected, the timer will be silent until
zero is reached. When zero is reached, a single beep will be played. With Beeps selected, beeps are
played at 30 seconds, 20 seconds and from 10 seconds down to zero. When the timer reaches zero, a
slightly longer beep will be played. And with Voice selected, ‘30 seconds’ is played at 30 seconds, ‘20
seconds at 20 seconds, 10,9,8,etc down to zero and finally a beep at zero.
●
Extended limits allow setting servo movement limits up to 125% instead of 100%.
●
Extended trims allows trims to cover the full stick range instead of +/-25%. Be careful when using this
option, as holding the trim tabs for too long might trim so much as to render your model unflyable. The
"Reset" item will reset all trims (for all flight modes).
●
Trim step sets the precision of trim clicks. Exponential means very fine steps close to the trim center, but
larger ones the farther you get from center.
●
Throttle reverse: Ensures correct operation of throttle-based timers and functions for people who like
having full throttle with the stick down.
●
Throttle source defines what triggers the THx functions of the timers. It's common to set it to the throttle
channel instead of the stick, so that throttle cut or other modifiers are taken into account.
●
Throttle trim: IC engine mode, where trim only affects the idle part of the throw without touching the full
throttle point.
●
Throttle Warning: Will warn you if the throttle stick is not at idle when the radio is powered up or a model is
loaded.
15
Summary of Contents for OpenTX 2.0+
Page 41: ...41...
Page 47: ...Taranis Updating internal XJT module firmware 47...
