●
Blades: Number of blades for the RPM sensor.
●
Voltage/current: Allows choosing the input for the power calculation and mAh count features. These should
match the input you've connected the corresponding sensors to.
●
Variometer source: sensor type that is installed in your model. "Vario" is for the new FrSky vario sensors
as well as the
(vertical speed is calculated by the sensor and transmitted digitally), A1/A2 are
for analog sensors that transmit vertical speed as a voltage connected to the respective input. Limit sets
respectively the maximum expected sink rate, low and high dead band (no sound), and maximum climb
rate for the sounds generated by the Vario custom function. The low dead band can be set to OFF, which
disables sink tones altogether.
Following those basic parameters are the selection lists for the 3 custom telemetry screens that can be seen by
LONG pressing the PAGE key on the main views. Each screen can either show numerical parameters (9 in the
main screen area and 3 in the bottom bar), or 4 bargraphs with configurable upper/lower limits.
Each field can be one of the various available parameters, of course the corresponding sensors and/or hub must
be installed in the model:
●
Tmr1,2: Both timers
●
SWR: Transmitter antenna quality. Should always be below 51, or a popup warning will appear and an
audio alarm will sound to warn you to check the radio's antenna. The value itself is of little meaning.
●
RSSI: Lowest of the RSSI values from the radio and receiver in D8 mode. In D16 mode, RSSI of the
receiver.
●
A1,2: Analog ports on D receivers (only A1 available on X8R receivers, with receiver voltage)
●
Alt: Barometric altitude sensor
●
Rpm: Engine speed, number of blades is adjusted in the settings above
●
Fuel: Fuel level
●
T1,T2: Temperature sensors 1 and 2
●
Spd, Dist, GAlt: GPS speed, distance from starting point and GPS altitude
●
Cell: Lowest cell on FLVS-01
●
Cels: Sum of all cells on FLVS-01
●
Vfas: FAS-40/100 voltage measurement
●
Curr: Current, source configured in the settings above (FAS or analog)
●
Cnsp: mAh used totalizer (needs current source configured correctly)
●
Powr: Power, voltage and current sources configured above
●
AccX,Y,Z: Acceleration values from TAS-01
●
Hdg: GPS heading
●
Vspd: Vertical speed (either calculated by the radio or reported by the sensor, depending on the sensor
type chosen above)
●
xxx+/xxx-: Min and max values of the available parameters
LUA Scripts
OpenTX 2.0 added support for Lua (current version 5.2.2) user scripts.
25
Summary of Contents for OpenTX 2.0+
Page 41: ...41...
Page 47: ...Taranis Updating internal XJT module firmware 47...
