Buddy Box/trainer
TODO use text from
http://www.rcgroups.com/forums/showpost.php?p=29067775&postcount=3404
http://www.rcgroups.com/forums/showpost.php?p=29069336&postcount=3421
http://www.rcgroups.com/forums/showpost.php?p=29069673&postcount=3423
Hardware Modifications
Taranis - Change from Mode1 to Mode2 (and vice versa)
Taranis - SH SF switch swap - Pats solderless method (good for RevA and RevB)
TODO use text from
http://www.rcgroups.com/forums/showpost.php?p=26467096&postcount=279
SH SF switch swap - solderless method
First thing I did to my Taranis today was swap the momentary with the 2 way switch on the other side. Didn't feel
like soldering in any wires, so here is how it can be done.
1) open radio
2) remove the nuts holding the two switches in place.
3) remove the switches and unplug the connectors from each.
4) plug the switches in to the opposite side.
5) re-install them. Keep the connectors facing left as before to get the correct switching directions.
Now to keep the programming the same: (Momentary switch has some special applications in opentx)
6)Carefully unplug connector from P8 on the RF daughter board (top one on the right side) pulling on alternate
ends seems to be the best way to remove it.
7) Swap the two wires shown, first from the left with third from the right.
(Use the tip of an xacto, small jewellers screwdriver to hold up the plastic tab while pulling on the wire) Make sure
they are in all the way and the right way up when you re-install them.
8) plug back in the connector. Support the free end of the PCB while rocking it in end to end as you did when
removing it. Make sure it is fully seated.
Done.
Ultimately i will replace the momentary with a SPDT ON-OFF-Momentary switch, that will probably require some
soldering.
While I had it open I used a bit of hot melt to fasten the wires to the switches to keep them away from the gimbals.
My throttle was hanging up on them a bit.
46
Summary of Contents for OpenTX 2.0+
Page 41: ...41...
Page 47: ...Taranis Updating internal XJT module firmware 47...