The Taranis hardware
The radio has a relatively standard design and control layout, namely:
●
2 sticks and their associated trims, labelled in the software as Thr, Rud, Ele, Ail and TrmT, TrmR, TrmE,
TrmA respectively. The stick to name mapping matches the selected stick mode. Trims are freely
assignable (e.g. for cross-trimming), and can also be used as independent controls.
●
2 adjustment pots, S1 and S2
●
2 lateral sliders, LS and RS
●
6 3-position switches (SA-SE, SG)
●
1 2-position switch (SF)
●
1 momentary switch (SH)
When selecting a switch position to activate functions, it is referred to as the switch name followed by the physical
position (SAup, SC-, SFdown). A ! before the name means NOT, so !SBdown would mean that the function is
active when SB is NOT down, i.e. when SB is either up or in the middle.
A swiveling antenna is installed for the internal RF module, and a speech-capable speaker is located under the
round grill. The large backlit, grayscale LCD and 6 edit keys take most of the lower part.
5
Summary of Contents for OpenTX 2.0+
Page 41: ...41...
Page 47: ...Taranis Updating internal XJT module firmware 47...