The second shows the gimbal and switches positions, and is handy to check that all the physical controls respond
as intended.
The third shows again the physical switches on the left, and the states of the 32 logical switches on the right.
The last view is a channel monitor showing the servo outputs for all 32 channels (+/- change page). If channel
names are defined on the SERVOS page, they will show up here instead of the numbers for convenience.
Telemetry view
A LONG press of the PAGE key from any of the main views brings up the telemetry views. The PAGE and +/- keys
will then cycle between the power status screen (voltage, current, power or A1/A2 if not set, cell voltages from an
FLVS-01 sensor if connected), the min/max and GPS coordinates screen, and if defined from one to three customs
screens that can hold up to 12 items each, configured in the telemetry setup menu.
9
Summary of Contents for OpenTX 2.0+
Page 41: ...41...
Page 47: ...Taranis Updating internal XJT module firmware 47...