I n w e l l h M E o p e r a t e d
As soon as t h e V O L - c o n s t a n t assembly is terminated, the Quadrocopter can be taken in
e nt e r pr is e
. They n e e d for it a
35-MHz A-volume remote control transmitter with the type of modulation PPM (at least 4 -Kanal),
a s u it a b le
pair of quartz
35MHz A-volume and a loaded 3 -Zelen LiPo accumulator with at least 2500mAh 25C upto max. 400 0mAh 20C.
Microtaster:
On the tax plate a Microtaster is installed, which can be used for the RESET of control electronics . In
addition you pressure the Microtaster at attached accumulator for approx. 1 S. thereafter start electronics again and
g o
into
the condition set
d e p e nd in g u p o n
Jumper.
1 .
R C - r e c e i v e r s p r e p a r e
For the enterprise of the Quadrocopters you need a FM -A-
volume 35-MHz-Quarzpaar and FM-A-volume a
35-MHz-Fernsteuersender w i t h the type of modulation PPM.
Select
t he s u it a b le
pair of quartz and be you to R (RX-) quartz
into the receiver of the Quadrocopters (see fig. 07) and the t (TX -) quartz into your remote control transmitter. You find the
receiver on middle electronics in the
Kunststofrahmen. They recognize it by the black antenna cable, w h i c h leaves.
Fig. 07 receiver quart z
I n t h e c a s e o f use of your already existing remote control plant is absolute
on the Kombatiblität to the receiver already inserted, to pay attention as well as to the
correct type of quartz (X -TAL).
A FM-A-volume 35-MHz-Quarz
must be used. Before the first flight a range test should
be always accomplished. Suitable o r i g i n a l q u a r t z find you with
or in our catalogs under „receiver single
quartz 35 MHz FM/A volume for Modelcraft receivers ".
Quarzmonta
g
e: Untere Abdeckun
g
mittels der vier Schrauben entfernen oder
Quarz durch die entfernte obere Abdeckun
g
mittels Pinzette oder
Winkelzan
g
e in d a s Em
p
fan
g
smodul einsetzen.
