L e a r n t h e c h a n n e l s
The Jumper R2 must
b e
set. If you scolded now your transmitter, take the antenna off of the transmitter completely. Make
sure that ale levers and trims of the transmitter are in Neutralstelung. The dargestelten e xamples s h o w the procedure
on
the basis a remote control in the mode 2nd
Fals you another mode prefer, can the used axles deviate (see in addition
appendix 1)!
Stelen it also surely that at the remote control the sliding controls for the trim are in the Neutralstelung!
Otherwise correct recognizing of the channels is not possible! Pay attention e b e n f a l s to the correct direction of
the lever movements, since anderenfals one t h e s i g n a l s are inverted
stored! Computer remote control plants always without mixers operate!
Move the Gashebel (see to fig. 11, here axle A) to the rear on the Nulstelung
(engine out), ale other control members on neutral.
If you should want to fly „pitch Reverse ", then you bring the Gas -Hebel into the max.
position forward, before you attach the accumulator.
G A S l e a r n
Attach the loaded accumulator at the Quadrocopter. This begins with a self check and
directly afterwards with the training of the channels. On the basis the Gasstelung the
Quadrocopter recognizes automatically, which channel you want t o u s e for the gas.
As confirmation
p u ls a t e s
the red LED of the Quadrocopters in the 2er rhythm (2x short
flashing, thereafter longer break, thereafter again 2x short flashing etc.)
G R E E D l e a r n
Move now the greed lever (see fig. 12, here to axle B) to the left below VOL excursion
and hold it there for at least one second.
The Quadrocopter recognizes thereby the yaw channel and stores this. Move GREED
backward the Neutralstelung, GAS further on nul.
As c o n f i r m a t i o n the red LED o f t h e Q u a d r o c o p t e r s in the 3er rhythm (3x short
pulsates
