14
Installation Lightcloud Gateway
Follow instructions and steps to successfully install your Gateway.
Installing the Lightcloud Gateway
Turn off the breaker and prepare
the circuit you’ll use to power the
Gateway. A dedicated circuit is
recommended.
Remove a knockout (KO)
from the Gateway using a
flat-blade screwdriver and
hammer. Place the screw-
driver blade at the edge of the
KO, then tap the screwdriver
with the hammer to weaken
the attachment. Work your
way around the edge of the
KO until it breaks away.
Choose a location with good
cellular signal. Check your
phone’s signal for reference.
NOTE
: Locations with significant
concrete and brick construction,
or underground locations, are not
recommended.
Do not install inside
metal enclosures.
1
2
3
OFF
OFF
WARNING
STEP ONE
STEP T WO
STEP THREE
3:14
Summary of Contents for Lightcloud
