®
WPLED 260W 360W INSTALLATION INSTRUCTIONS
Thank you for buying RC lighting fixtures. Our goal is to design the best quality products to get the job done right. We’d like to hear your comments.
Call the Marketing Department at 888-722-1000 or email: marketing@rclighting.ca
CAUTION
For proper weatherproof function all gaskets must be seated properly and all screws inserted and tightened firmly. Apply
weatherproof silicone sealant around the edge of the Back Box and/or Junction Box. This is especially important with an
uneven wall surface. Silicone all plugs and unused conduit entries.
MOUNTING ARM ON FIXTURE
1.
Remove the
Arm Cover
from the
Arm
.
2.
Feed wires from
Fixture
through
Gasket
into
Arm
.
3.
Line up
Arm
and
Fixture
. Place flat washers, lock washers
and nuts on the
Short 3/8-16 bolts
inside the
Arm
and
tighten securely to housing.
4.
Make sure the
Arm Gasket
is secure between
Arm
and
Fixture
.
5.
Replace the
Arm Cover
. Be sure
Arm Cover Gasket
on
Arm Cover
is in place.
“COM”
PHOTOCELL
WP2FC
LIGHT
FIXTURE
BLACK
WHITE
PHOTOCELL
PHOTOCELL INSTALLATION
Photocell may be wired in the field. Apply weatherproof
silicone sealant to all plugs and unused conduit entries.
1. Knockout hole on top of arm.
2. Install photocell and wire as per diagram.
3. Use photocell rated for your supply voltage.
Screws (2)
Arm
Fixture
Short 3/8”
Bolts
Gasket
Arm Cover
Plugs (2)
WPLED 260/360W
WPLED FX 260/360W
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE
.
RC fixtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper grounding is
required for safety. This product must be installed in accordance with the applicable installation code by a person familiar with the
construction and operation of the product and the hazards involved.
WARNING: Make certain power is OFF before installing or maintaining fixture. No user serviceable parts inside.
CAUTION: The fixture weighs 80lbs. Make sure pole and hardware supplied by others (if any) can withstand the weight of
the fixture.
