RC Logger 88001RC, Operating Instructions Manual

P. 25

Programming of transmitter Channels (general)

QC-09

LD1 (the green LED)

>

LD2 (the red LED)

>

X5:.Interface.to.extension.boards

>

X1.and.X2:.Interface.to.motor.drivers

>

dIP switches

Parameter settings sport

1. 

Parameter settings user

2. 

Boot loader mode

3. 

RC.configuration

4. 

No.function.yet.defined

5. 

No.function.yet.defined

6. 

Before.you.begin.programming,.unplug.the.rechargeable.battery,.if.connected,.from.the.RC.EYE.650..Also.disconnect.the.connection.cable.

to.the.PC,.if.connected,.from.the.RC.EYE.650..

Switch.the.DIP.4.on.the.QC-09.to.ON.position..On.one.side.of.the.QC-09,.both.of.the.LEDs.(LD1,.LD2).indicate.particular.operating.statuses..

1. 

Before switching the transmitter on, set the throttle stick to “motors off” and all trim levers / trim sliding controllers of the 

pilot stick to the neutral position. otherwise, the rC eye 650 may not recognise the transmitter after the battery is connected. 

Now switch on the transmitter. 

2. 

Ensure that all levers and trims of the transmitter are in neutral position. The example given shows the procedure using a remote control 

in.mode.2..If.you.prefer.to.use.another.mode,.the.axes.used.may.differ.(see.chapter.“Possible.flight.modes”)!.

Also ensure that the sliding 

controller for the trim is set to neutral position! Otherwise correct recognition of the channels will not be possible! 

Ensure that lever movements are made in the right direction, otherwise the signals will be memorised in reverse! Computer remote 

controls should always be operated without mixer! 

Move.the.throttle.lever.backwards.to.the.neutral.position.(motor.off),.all.other.control.devices.should.be.set.to.neutral..

3. 

Do.you.want.to.try.out.“nick.reverse”?.(During.“motor.off”.the.pilot.stick.for.throttle.is.pulled.away.from.the.body),.then.bring.the.throttle.

4. 

lever forwards into the max. position before you connect the rechargeable battery. 

Programming of “throttle”

Connect.the.charged.battery.to.the.RC.EYE.650..The.model.starts.with.a.self-test.and.directly.continues.with.programming.of.the.channels..

1. 

On.the.basis.of.the.throttle.setting,.the.RC.EYE.650.automatically.recognizes.which.channel.you.would.like.to.use.for.the.throttle..
As.confirmation,.the.red.LED.(LD2).on.the.combined.flight.control.board.will.flash,.twice.in.a.cycle.

2.