34
12. bIndIng 2.4 ghz TX and rX
Before you start binding your TX and RX make sure that you have installed the AAA batteries into the
2.4 GHz transmitter.
1.
Install flight battery into your RC EYE One S and connect the battery. The RC EYE’s status LED should
go solid green.
2.
Press and hold the ‘bind button’ of the RC EYE One S located next to the battery tray until the status
LED starts to flash red/green.
3.
Make sure that the throttle stick is at full zero. Turn the transmitter on (two beeps), turn it off (one beep),
press and hold the ON/OFF button again until you hear a beep sound every 3 seconds. You are now
in binding mode.
4. Wait until the RC EYE’s status LED flashes in the corresponding color related to the selected flight mode
indicating that the binding process has been completed. You need to perform step 1. – 4. within a given
time, otherwise binding will not be successful.
5.
Note: The previously known flight mode selection button (now referred to as ‘bind button’) is no longer
used to toggle between different flight modes. It is now only used to enter the binding mode!
13. 2.4 ghz frequenCy hoPPIng – “fhss”
The RC EYE One S transmitter and receiver are based on 2.4 GHz FHSS technology. This modulation
technique is repeatedly switching frequencies during radio transmission with the objective of minimizing
the unauthorized interception and/or jamming other transmitting or receiving devices such as cellphones,
wireless networks, remote controlled toys, virtually any 2.4 GHz operated product. This technology is
commonly referred to as “frequency hopping spread spectrum” or simply “FHSS”.
As a result, users are not required to select a specific radio channel, since this is done automatically via
FHSS. Thus users may operate this product within a geographical area side by side with additional remote
controlled products and other transmitting or receiving devices.
14. MaInTenanCe, Care and rePaIr
regular Cleaning
The “RC EYE One S” is a very simple but nonetheless well-designed flying device. There are no mechanical
parts that need to be lubricated or require special maintenance. However, after each flight operation you
should clean the “RC EYE One S” of possible dirt (wool strings, dust, etc.).
For cleaning, use a dry or slightly damp cloth and avoid contact between water and the electronics,
rechargeable battery and motors.
Do not fly without covering the electronics. Please ensure that no moisture enters the inner central piece.
Never fly when it is raining!
Summary of Contents for 88005RC
Page 18: ...18 Figure 2a Figure 2b...
Page 21: ...21 Figure 4a Figure 4b...
Page 23: ...23 Figure 5b...
Page 26: ...26 Figure 7a Figure 7b...
