37
2.
For reference, put the “RC EYE One S” onto your work surface with the model LED (see arrow) pointing
to the front right.
3.
The front motors (motor 1 and 2) are at the “front” for this model and must have red propellers. Motor 1
turns counter clockwise, motor 2 turns clockwise.
4. The rear motors (motor 3 and 4) must have black propellers. Motor 3 turns clockwise, motor 4 turns
counter clockwise.
5.
Do not bend the motor shafts. Bent motor shafts (e.g. from crashes) influence the flight properties
negatively due to the vibration that results and the irritation to the sensors. Motors with bent motor shaft
must be replaced.
replacing a motor
1.
Remove the defective motor by removing the screw from the motor boom. Pull the motor holder from the
boom. Make sure to use a proper precision screwdriver. Do not damage the screw-head!
2. Unplug the motor cable from the motor.
3.
Replace the defective motor and re-install the motor into the boom. Secure back the fixing screw. Do not
tighten the screw too much as you may damage the motor mount.
Summary of Contents for 88005RC
Page 18: ...18 Figure 2a Figure 2b...
Page 21: ...21 Figure 4a Figure 4b...
Page 23: ...23 Figure 5b...
Page 26: ...26 Figure 7a Figure 7b...
