RC Logger RC EYE One, Operating Instructions Manual

14

9. SAFETY INSTALLATION

The “RC EYE One” has a range of safety devices in the transmitter and model which 
protect the model from damage and/or should reduce possible damage to a minimum. The 
        
(transmitter).

Transmitter

>

The charge condition of the inserted batteries is inspected every time the transmitter is switched on. If 
the charge condition is too low, the transmitter switches off immediately again. The transmitter signals 
this by three subsequent warning sounds.

>

The charge condition is continually inspected while the transmitter is in operation. If the charge condition 
drops below a certain value, the transmitter also signals this with a triple warning sound. In this case, 
 %        

>

The transmitter also has a deactivation automatic integrated. If no control element is operated for more 
      $  

Model

>

The LED in the “RC EYE One” shows if the transmitter is “bound” to the model and reception of the 
 %]'^]'^%  %
mode that is set.

>

;  $   ]'^     %
;    %    $  
_*  +

>

Short-term reception interferences are ignored by the “RC EYE One” by the last control signals of the 
      %   $    

>

The “RC EYE One” constantly monitors the voltage of the connected batteries. If it falls below a critical 
   $ %]'^

>

If the voltage undercut is permanently below a certain value, the LED is lit permanently orange. In this 
case, an emergency landing is initiated after a short period and the motors and LED are deactivated.

 !" #$   % &%
   $'*+ 0 3%
$ 4    6'
7 %$ 3  '703 
   %      0$'
If the “RC EYE One” is connected to a non-fully charged battery, this can also lead to 
 3   '7 %0$
0  8+00  '

As another safety measure, the motors are switched off once one or several rotors are blocked. If this is 
  ]'^ % &      
  %