Page 3
TC3 “O” V2
RC Product Designs
Tools Required
⇒
Allen wrenches: 1/16" and 3/32"
⇒
Molded tools from Associated
#6956
⇒
Dremmel Cutting Tool & File
⇒
Pencil
⇒
1/8” & 3/16” drill & 82 degree
Countersink ¼” diameter
⇒
Needle-nose pliers
Warning!
It is recommended to always wear
Eye Protection when using any
Power Tools and a Dust Mask if
grinding/sanding plastic, graphite
or metal parts.
Recommended Tools:
⇒
3/32" driver
⇒
1/16" driver
⇒
3/16" nut driver
⇒
11/32" nut driver
Parts you will need to complete the kit:
⇒
R/C 2-channel surface frequency radio system.
⇒
Battery pack (6 cell).
⇒
Electronic speed control.
⇒
R/C electric motor.
⇒
Pinion gear, size to be determined by type and wind of motor you will be
using.
⇒
Your donor TC3 chassis.
⇒
Associated B4 Buggy Shocks or other suitable buggy shocks.
⇒
4WD Off-Road Tires.
⇒
Steering & Camber Link Turnbuckles
⇒
One trapped end/eyelet for the steering link end on the bell crank.
Recommended upgrades:
⇒
Replacing plastic steering knuckles with Aluminum ones
⇒
Replacing plastic center shaft drive cups with Aluminum ones
⇒
On tight technical tracks use a front one-way (Associated P/N: 3978) or a
mid-shaft one-way (aftermarket).
