RC-Xplanes EDGE 540 T Outrunner Tabs Instruction Manual
Page 2 of 10
Distributed by RC-Xplanes 541-261-2707
rcxplanes.com
A
2005
Unpacking Your RC-Xplanes Kit
Please read all of these instructions before proceeding. This can save you time and money by avoiding costly mistakes.
Congratulations on the purchase of your new RC-Xplanes EDGE 540 T
.
We guarantee that if you follow these
instructions and maximum performance power equipment recommendations, you will be rewarded with the best
flying 3D foam aircraft available
Inside the box you will find all of the necessary laser cut and pre grooved foam parts and hardware to complete
your airframe. Immediately remove from the bags and inventory all parts included. This is what you should find
inside.
1 bag of laser cut Depron foam parts
including:
1. 1=
Fuselage
2. 1=
Wing
3. 1= Horizontal Stabilizer
4. 2=
Elevators
5. 1=
Rudder
6. 2=
Ailerons
7. 2= Front 90 degree supports
8. 2= Rear 90 degree supports
9. 2= 45 degree supports
10. 4= servo mounts
1 long parts bag including:
1. 1= 36” x .156 carbon tube
2. 1= 6” x .156 carbon tube
3. 2= 3” x .156 carbon tube
4. 1= 24” x .050 carbon rod
5. 1= 24” x .032 steel wire
6. 1= 2” length heat shrink
7. 1= 2.75” x 3/8” square
hardwood motor mount
1 small parts bag including:
1. 15= DuBro Micro hinges
2. 4= DuBro Micro control
horns
3.
4= DuBro Micro E-Z links
4. 4= DuBro Micro E-Z
connectors
If you ordered the SMS Outrunner
motor package you will also find 1
SMS mount parts bag Including:
1. 8= Lexan Fuse Stiffeners
2. 4= 4-40 x 3/8 nuts
3. 4= Nylon 4-40 screws
These instructions are posted on the
Construction Page at
www.rcxplanes.com
in PDF format to
allow you to zoom in on any pictures
for clarity.
What you will need to complete your RC-Xplanes EDGE 540 T
kit
Power Recommendations
Radio
Adhesives and tools
Motor Combos:
1. Hacker A20-22L motor, X20
ESC, APC 11x4.7 Slow Fly
prop.
2. AXI 2212/26, Phoenix 25
ESC, APC 11 x 4.7 Slow Fly
Prop,
3. Himax 2015-5400 or Park
370 5400, 6.6:1 Gearbox,
Phoenix 25 ESC, GWS 12 x
6 Slow Fly Prop. For stick
mount kits.
Battery:
1. Thunder Power Gen 2, 1320
mAh 3s1p
4 or 6 channel transmitter and
receiver.
4 Micro servos.
Radio and servo choices are very
subjective. We recommend a good
6 channel computer radio and a 6
channel micro receiver for the
added ability of some fun mixes.
RC-Xplanes Thin CA
RC-Xplanes Medium CA
RC-Xplanes CA accelerant
RC-Xplanes 5 minute epoxy
¾” package strapping tape
Hobby knife
Small screwdrivers
Rulers
Fine point Sharpie
Carbon and metal cutting tools
