RC4WD USA 100-0012
3CH Transmitter / Radio
Step 1. Transmitter and Receiver Overview
Step 2. Receiver and Servo Connection
Step 3. Installing the Batteries
Connect to Motor
Connect to Battery
Power Switch
Steering Servo
E. S. C.
CH2
CH1
E. S. C.
Receiver
SWITCH
FAIL SAFE SET
TRIGGER
CHANNEL 3 SWITCH
BATT BOX
GRIP HANDLE
POWER
ST TRIM
TH TRIM
ST EPA
TH EPA
TH REV
STEERING
WHEEL
3CH EPA
ST REV
2.4G ANT
RC4WD
Connectors
1: Steering Servo (CH1)
2: Throttle Servo (CH2)
3: CH3 Servo (CH3)
4: CH4 Servo (CH4)
B/C: Power Connector
(1) Remove the battery compartment cover.
(2) Install four (4) new AA batteries.
Warning: Please replace batteries when the
power indicator blinks or the buzzer beeps.
Battery
RC4WD
Connect to
Receiver Battery
Power Switch
(8)
CH2
CH3
CH4
Channel 4 Servo
Channel 3 Servo
Throttle Servo
Steering Servo
CH1
Electric Powered Model
Gas Powered Model
5
• Water-proof and dust-proof, suitable for all-weather conditions.
• Small size with built-in capacitor module.
• Three running modes: Fwd/Br, Fwd/Rev/Br and Fwd/Rev, fits for various
vehicles. Note 1: Fwd =Forward, Br=Brake, Rev=Reverse.
• Great current endurance capability.
• Great built-in BEC output capacity.
• Automatic throttle range calibration, easy to use.
• ESC parameters can be easily changed by changing the jumper pins.
• Multiple protections: Low voltage cut-off protection for battery / Over-heat
protection / Throttle signal loss protection.
