III
RC4WD Trail Finder 2 Truck Kit LWB
■ Use good quality hex drivers to avoid stripping screw heads.
■ Open kit bags in order of assembly steps.
■ Use “Step” index for quantity and size of hardware to be used for assembly.
■ Do not over tighten screws.
■ Use thread lock sparingly on metal parts.
Recommendations for building your
RC4WD Trail Finder 2 Truck Kit LWB
1. Carefully remove all parts from bags and sort them. Make sure to use threadlock on all
screws in aluminum.
2. Do not over-tighten screws. Stripping screw heads and holes during assembly can
happen if you are using too much force.
Tips for Assembly
Build Front and Rear
Attention
Paint
Build Right and Left
Repeat or Build Multiple
Cut with Scissors
Remove
CA Glue
Trim with Hobby Knife
Glue
Apply Grease
Apply Thread Lock
Instruction Manual Symbols Key