Note: The controller uses 4 AA batteries
Main vehicle battery: 7.4V 2S lithium battery
(battery connector is
XT60)
Battery size: Length 83MM width 40MM height 16MM
(battery and
power display need to be purchased separately)
Steps:
1. Before turning on the controller, check that the position of each
switch is up and the joystick returns to the middle position.
2. Turn on the controller switch. (the switch should be in the up
position)
3. Connect the main vehicle power supply,
and operate after
confirming the signal sound. (about 5S)
note:
1. It is very likely that the ESC will enter the setting mode if it is
operated in advance, which will cause the ESC to not work
properly.
2. Controller battery installation: Pay attention to the positive and
negative terminals of the battery during installation.
3. Before the main vehicle battery is installed: Measure the voltage
first, the voltage cannot be lower than 7.4V.
Summary of Contents for VV-JD00036
