7
Using the Remote Control
Buttons on the Remote Control
(0-9) Number buttons
Allows direct access to any channel. Two buttons must be
pressed to select a channel when you set
ANTENNA
to
AIR
. For channels 2 through 9,
press 0 fi rst, then the channel number (for example, 02, 12). Three buttons must be
pressed when you select a channel number under 20 if you set
ANTENNA
to
CABLE
,
and for channels above 19, you can enter the three digits directly. For example, 001,
019, 20, 100.
CODE
Allows you to change your P.LOCK (Parental lock) password (see page 12).
DISPLAY
Displays the current channel information (such as channel, time, etc.). Press
it again to exit.
FREE LISTEN
This button has no function on this model.
MENU
Displays the Main menu.
MUTE
Reduces the TV’s volume to its minimum level. Press again to restore the
volume.
PICTURE
Allows you to toggle the available picture settings:
DYNAMIC, SOFT,
STANDARD,
and
PERSONAL
.
POWER
Turns the TV on and off.
PROG. (PROGRAM) buttons /
Press the button to go to the next channel in
memory. Press the button to go to the previous channel in memory.
Q.VIEW (QUICK VIEW)
Allows you to go back to the previous channel selected by
just pressing the Q.VIEW button. Press again to return to your last channel.
TIMER
Sets the sleep timer.
TV/AV
Toggles between regular TV programming and the Video Input Channels (TV1/
AV1/AV2).
VOL (VOLUME) buttons /
Increases and decreases the volume.
Battery Precautions
These precautions should be followed when using batteries in
this device:
1. Use only the size and type of batteries specifi ed.
2. Be sure to follow the correct polarity when installing the
batteries as indicated in the battery compartment. Reversed
batteries may cause damage to the device.
3. Do not mix different types of batteries together (e.g.
Alkaline and Carbon-zinc) or old batteries with fresh ones.
4. If the device is not to be used for a long period of time,
remove the batteries to prevent damage or injury from
possible battery leakage.
5. Do not try to recharge batteries not intended to be
recharged; they can overheat and rupture. (Follow battery
manufacturer’s directions.)
Installing the Batteries
Before using the remote control for this fi rst time, you
need to install batteries.
1. Open the battery compartment cover.
2. Install two “AAA” batteries (not supplied).
3. Replace the battery compartment cover.
The batteries may last approximately one year
depending on how much the remote control is used.
For best performance, it is recommended that batteries
should be replaced on a yearly basis, or when the
remote operation becomes erratic. Do not mix old and
new batteries or different types.
Summary of Contents for 14B042
Page 23: ......