8
Chapter 2
Graphics contained within this publication are for representation only.
Chapter 2: Using the Remote Control
Button Descriptions for TV Mode
Arrows
Used to point to different items in the TV menu and to adjust the menu
controls.
Indicator
Indicates the programming mode when programming the remote to
control components. Lights when you press a valid button on the remote. Flickers
when a button is pressed and the batteries are low.
(0-9) Number Buttons
Enter channel numbers and time settings directly
through the remote control.
To enter a one-digit channel, enter a zero first. To enter a two-digit channel, press
the two digits and expect a few seconds delay. This is in case you want to enter a
third digit.
CH + or CH -
Scans up or down through the current channel list. Press once to
change the channel up or down; press and hold to continue changing channels.
CLEAR
Removes any menu or display from the screen and returns you to normal
viewing.
GO BACK
Returns you to the previous channel.
INFO
Brings up channel banner; press again to clear the screen.
MENU
Brings up the Main menu.
MUTE
Reduces the TV’s volume to its minimum level. Press again to restore the
volume.
OK
When in the menu system, selects highlighted items.
ON•OFF
When in TV mode, turns the TV on and off. If in another mode (VCR,
DVD, SAT•CABLE, etc.), will turn the component on and off.
SKIP
Press once before changing channels and the TV will go back to the original
channel after 30 seconds. Press repeatedly to add more time.
SOUND
Displays the SOUND menu.
TV
Turns on the TV and puts the remote in TV mode. Also displays current status.
VOL – or VOL +
Decreases or increases the TV’s volume.
WHO•INPUT
In TV mode, press to toggle through the available input sources
(VID1/SVID1, VID2/CVID2, FRNT, CVID3 and current channel). In SAT mode, press to
select available channel lists.
Button Descriptions for Other Modes
AUX
Puts the remote in AUX mode. Can also be programmed to operate most
brands of an additional remote-controllable component.
ANTENNA
In VCR mode, functions as a TV/VCR button. In SAT•CABLE mode,
functions as a TV/receiver button.
DVD
Puts the remote in DVD mode and, if auto tuning is enabled, will turn on the
TV and tune to the correct video input channel.
GUIDE
If you’re operating another component that has an on-screen program
guide, this button accesses the on-screen guide.
STOP
PAUSE
TV
ON OFF
AUX
DVD
SAT•CABLE
PLAY
FORWARD
REVERSE
SOUND
GO BACK
CH +
CH -
V
O
L
V
O
L
SKIP
MUTE
INFO
MENU
OK
CLEAR
GUIDE
ANTENNA
1
2
3
4
5
6
7
8
9
0
WHO•INPUT
VCR1
RECORD
VCR2
Indicator
1616362B.02_Remote
4/22/04, 7:44 PM
8
