8
Step B: Installing the inside diplexers
1. Disconnect the satellite cable from the
“SAT IN” terminal on your satellite receiver.
2. Connect the satellite cable to the terminal marked
“TV/SAT” on the inside diplexer (see Fig 7 on page 8).
3. Connect one of the supplied white 12” connector cables
from the terminal labeled “SAT” on the inside diplexer
to your satellite receiver’s “SAT IN” terminal (see Fig 8
on page 8).
4. Connect the other white 12” connector cable from the
terminal labeled “TV” on the inside diplexer to your
satellite receiver’s “ANT IN” terminal (see Fig 9 on
page 9).
5. Connect a coaxial cable (not supplied) from the satellite
receiver’s “TV OUT” terminal to your television or
VCR (see Fig 10 on page 9).
6. Repeat step for each satellite receiver.
7. Continue to “Step C: Setting Up Your TV to Use the
ANT3901” (page 9).
Fig 7
Fig 8
ANT3901new 4/29/03 8:37 Page 8
