5
B. Secure the mast to the mounting base.
Pieces Used:
(1) Mast
(2) 1/4”x48
mounting bolts
(2) Hex nuts
Insert the mast into the middle of the
mounting base as illustrated here. Then insert
one of the 1/4”x48 mounting bolts through
the bottom hole on the side of the mounting
base and mast as shown. Screw one of the
hex nuts onto the end of the bolt to hold the
mast and base together. Don’t tighten the nut
completely yet.
Insert the other 1/4”x48 mounting bolt through
the slot on the side of the mounting base and
mast as shown. Screw the second hex nuts
onto the end of the second bolt.
Position the mast so that it’s perpendicular to
the ground (plumb). Then tighten the two hex
nuts to hold the mast in this position.
C. Secure the antenna to the mast.
Pieces Used:
(2) Clamps
(4) Wing
nuts
Place the two sets of
mounting bolts attached
to the back of the antenna
bracket on either side of the
mounting mast.
Place the clamps over the
ends of the mounting bolts as
shown here.
Screw the wing nuts onto the
ends of the mounting bolts.
Tighten them so the clamp
holds the antenna on the
mast securely.
Antenna
bracket, back
Mast
Antenna
mounting bolts
Clamp
Clamp
Antenna
mounting bolts
Summary of Contents for ANT950E
Page 8: ...E n g l i s h v e r s i o n o n b a ...
Page 9: ......
