BR200D-U1/BR300D-U1
Service Manual
14
* Do not disassemble the battery case.
Installing/Removing Antenna, Channel Selector, Power/Volume Knob
Screw the antenna out of the connector at the top of the radio by holding the bottom of the
antenna and turn it counter clockwise until apart.
Using a smooth tool or a tool protected with cloth to hold or prize up form the bottom of
channel selector or volume knob until apart.
Install external speaker/MIC
Open the cover of the jack for external speaker/MIC, and then insert the plug of the external
speaker or microphone into the jack on the radio. When inserting the accessory plug, make
sure it is properly aligned ( straight) to avoid internal damage to the connector in the radio.
Installing/Removing the Belt Clip
Summary of Contents for BR200D-U1
