BR200D-U1/BR300D-U1
Service Manual
15
Use the 2 screws (M2.5x8.0) supplied with the radio and fix these screws on the holes in
the radio clip and into the holes in the aluminum case. If you want to remove the clip from
the radio, just unscrew them, and remove the clip, you can put the screws back to make
sure you do not loose them.
Installing/Removing the Chassis, PCB
1
.
Remove the antenna, channel selector and power/volume knob.
2
.
Screw off the two screws at the bottom of the radio by a hexagon screwdriver.
3
.
Pry up the aluminum shell by peaking a straight screwdriver in the cross-slot at the
Summary of Contents for BR200D-U1
