Chapter 4
31
VCR Features
CHANNEL SET
Auto Channel Search
Add/Remove Channels
Signal Type:
CABLE
Cable Box Setup
Channel Change:
CH3
Move:
Select:
End:
MENU
OK
Auto DST (Daylight Savings Time)
Adjust this setting to allow for daylight savings time (DST).
If you choose
OK
, the VCR sets the clock using any DST information broadcast in the channel’s signal.
Timer Recordings
The Timer Recordings feature programs the VCR to record automatically. This feature is explained in
detail on page 27.
Channel Set
Channel Set tells the VCR where to find channels and stores
them in the VCR’s channel list.
Auto Channel Search
Use Auto Channel Search to place all available channels in
memory.
If you ever change cable or antenna signals, you may need
to run the Auto Channel Search feature again.
Select one of the three options:
Cable TV
searches for cable stations.
Antenna
searches for local broadcast stations.
Detect Automatically
selects the appropriate input
automatically.
Note: With Detect Automatically, a strong cable or antenna signal
in your area may cause channels to be detected inaccurately. If
this should happen, you will need to select either Cable TV or
Antenna manually.
When scanning is complete, the VCR tunes to the lowest
channel available. After completing Auto Channel Search,
press the remote control’s CH + or - buttons to select active
channels.
Add/Remove Channels
Your VCR may come with a list of channels preset at the factory. Even though it may come with such a
list, you may want to add or delete certain channels.
Note: If you use a cable box to view all channels, this step is not necessary.
To go to the channel you want to add or remove, use the up or down arrow buttons or enter a specific
channel number using the number buttons.
To remove a channel from the channel list, press the left arrow button. To add a channel to the channel
list, press the right arrow button.
Note: To view active channels, use the remote control’s up and down arrow buttons. You can also access channels
that aren’t available in the active channel list by using the remote control’s number buttons to enter the specific
channel number.
DRC6200N.04 VCR Features
7/28/03, 9:31 AM
31
