24
Using the Remote
Programming the Remote
The universal remote can be programmed to control most brands of
remote controllable VCRs, satellite receivers and cable boxes. The
remote is already programmed to control most RCA, GE and PROSCAN
TVs, VCRs, DVD players, laserdisc players and satellite receivers.
Testing the Remote
To determine whether the universal remote needs to be programmed,
turn a device ON, such as a VCR, point the remote at the VCR, and press
the VCR1 button. Then press ON•OFF or CH + (channel up) or CH -
(channel down) to see if the VCR responds to the remote commands. If
not, the remote needs to be programmed.
Programming the Remote
Using Automatic Code Search
The following instructions can be used to program the remote to
control each of the devices connected to your TV. If you want to exit the
automatic code search without programming any of your devices, press
and hold CLEAR until the LED turns off.
1.
Turn on the device you want to control (VCR, SAT, etc.).
2.
Press and hold the button you want to program (VCR1, VCR2, etc.).
Note that the AUX button can only be programmed using direct
code entry. (See the next section for details.) While holding the
device button, press and hold ON•OFF until the red light on the
remote turns on, then release both buttons.
3.
Point the remote at the device, press and release PLAY, then wait
five seconds or until the LED stops flashing.
At this point the remote is searching for the correct code to
program. If, after five seconds, the device you want to control does
not turn off, press PLAY again to tell the remote to search the next
set of codes.
Continue pressing PLAY until the device turns off or you have
searched through all of the codes. There are 20 total sets of codes.
If the device does not turn off after pressing PLAY 20 times, then
the remote cannot control that particular device.
If the device you want to control
does
turn off:
1.
Press and release REVERSE, then wait two seconds. Repeat this
step until the device turns back ON.
2.
To finish, press and hold STOP until the red light on the remote
turns off.
You’ll use these buttons when you
program the remote to control any
device.
The remote may not operate all models
of all brands.
STOP
TV
ON OFF
AUX
DVD
SAT CABLE
PLAY
REVERSE
CH
+
CH -
V
O
L
V
O
L
VCR1
VCR2
